![]() ![]() Pump doesn't run when system HALT while Antifrost routine is heating water in the tank. Solution: Update the firmware to version 1.10.1 or above. TI Connect is a free IT and development software that allows users to transfer files between a TI graphing calculator and a computer using a link cable. This might cause fatal error in case system stays in Ramp-Up and have no water supply because it will not stop production of hydrogen in 80 min timeout and will continue to work even the electrolyte will reach very low level. The system must reach Steady to start Ramp-Down procedure. This issue will be fixed in future FW releases.Įlectrolyser doesn't stop during Ramp-Up if no more electrolyte left in the tank. Solution: To resolve the issue you will need to manually reboot the device. If the WiFi router power cut happens for a very short period it is possible that one of the devices connected to the MESH network won't be able to connect to the cloud and will have the offline status. Solution: Use a local ethernet connection to the electrolyser or IP address as a hostname. The list below contains the most important problems in the firmware and their solutions.Īn issue (opens new window) using WiFi and Windows to access the. Instead use holding registers #4026 (Enapter Chassis Serial Number) and #4376 (Enapter Stack Serial Number). ![]() Input registers #14 (Cabinet (Chassis) Serial Number) and #1000 (Stack Serial Number) are deprecated. Holding register #6018 is used for Start and Stop the Dryer starting from firmware 1.6.0. TI-Connect 1.6 Vista Setup By Matt Miller September 2007 / Rev. Ti connect version 1.6.1 Bluetooth It all works great. Instead of using it for checking that Electrolyser reached Max Pressure it is recommended to use input register #1200 (4 = Stand-By (Max Pressure)). NOTE: Prior to downloading any software to a computer used for instrument control/operation, please consult with your Service and Support. Ti connect version 1.6.1 Bluetooth So if youre on the latest Resolve version (17.2.2) and the latest Speed Editor firmware (1.4) and are still having issues, I urge you to look into the possibility of a poor RF connection. Modbus Communication Backward Compatibility PC - party compatible, check additional notes.Please carefully check the compatibility matrix for the 1.6.1 firmware version with the previous version. Changed check period for membrane failure. ![]() If Site has Enapter Gateway it needs to be updated to version 1.8.9 or higher. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |